irLEDFLAT QC -
5 RGBW LEDs compact projector with infrared remote control
Page 5
English
4 - Rear pannel description
1
Power input/output socket
Allows you to connect the projector to an
electrical outlet and to link several projectors
together via a Male/Female IEC cord.
Please make sure the voltage is in adequation with
the product indications.
Caution : Do NOT go over 700W on the same power
source.
2
Fuse
If need to replace the fuse, please make sure the
new fuse has exactly the same characteristics as the
original one.
3
DMX input
3-pin female XLR plug hardwired as follows :
- Mass: 1
- Negative signal: 2
- Positive signal: 3
4
DMX output
3-pin male XLR plug hardwired as follows :
- Mass: 1
- Negative signal: 2
- Positive signal: 3
5
Display
This intuitive display allows you to configure your
projector. Please refer to the next paragraphs for
more details about the projector configuration.
6
MODE button
Allows you to access menus and select a function.
7
SETUP button
Allows you to configure the parameters of the
functions chosen with the MODE button.
8
UP button
Press UP to increase the adjustable values or browse
the sub-menus.
9
DOWN button
Press DOWN to decrease the adjustable values or
browse the sub-menus.
10
Infrared receiver input
This Jack 3.5 plug allows you to connect the infrared
repeater system.
This receiver can be used when the front sensor of
the projector is too far to receive the remote control
commands.
5
6
8
7
9
3
4
10
1
2
