Evora-SP60
- 60W LED compact moving head with motorized focus and prisms
Page 17
English
Once switched on the unit will launch an initialisation. The display will indicate "XXEr" if a problem occurs
with one or several channels. If a problem occurs on channel 1 the display will indicate « 01Er » , « 02Er »
for channel 2, and so on.
If you encounter problems with channel 1, 2 and 5, the following message will be indicated: « 01Er »,
« 02Er », « 05Er ». It will flash 5 times. The device will then reset and all motors will go back to their initial
position. If the message keeps ocurring after 3 resets, there are more than 3 errors. The channels cannot
operate properly if there are more than 3 errors. If less than 3 errors, the concerned channels will be
deactivated but the projector can be operated.
: Colour wheel error.
This message appears after the initialisation of the unit if the magnetic position sensor of the colour wheel
is defective or misplaced.
: Gobo wheel error.
This message appears after the initialisation of the unit if the magnetic position sensor of the gobo wheel
is defective or misplaced.
: Gobos indexation error.
This message appears after the initialisation of the unit if the magnetic position sensor of the gobo
indexation is defective or misplaced.
: PAN (yoke) movement error.
This message appears after the initialisation of the unit if the magnetic position sensor of the PAN
movement is defective or misplaced.
: TILT (head) movement error.
This message appears after the initialisation of the unit if the magnetic position sensor of the TILT
movement is defective or misplaced.
: Error on the prism channel.
This message appears after the initialisation of the unit if the magnetic position sensor of the prism is
defective or misplaced.
: Error on the focus channel.
This message appears after the initialisation of the unit if the the magnetic position sensor of the prism is
defective or misplaced.
Errors may have various origins. Sensors are used to set the motors in their default position.
Either the magnetic sensors are defective, or the magnets have been displaced.
Problems might also come from a defective motor or the motor electronic management.
In any case, please write down the error displayed and contact your retailer to launch a maintenance
procedure.
Do NOT attempt to repair it by yourself as only Contest-approved technicians are allowed to perform
maintenance operations.
10 - Error messages
