Contemporary
Research
8
ICC2-ATSC HDTV Tuner/Controller
On-Screen Menus (IC Mode)
The remaining installation steps use the IR remote and the built-in character generator of the
ICC2-ATSC.
1.
Touch Menu, then 999, then Enter.
2.
The text CR MENU> should appear on the screen.
3.
Key in one of the commands shown below, then press Enter to activate.
4.
Note that, in Menu mode, the Channel Down key acts as a backspace/delete key.
Command Function
45678
Display firmware version
45679
Display the unit’s device #. At this point, you can use the Channel Down key as a
Delete key, enter a new device # with the remote’s numeric keypad, then hit Enter to
save the new number.
45700
Display or edit projector control commands. Sets the IR/RS-232 control format to
match your projector or display. In many cases, CR will pre-set this command to the
format specified by the dealer.
See
RS-232 Control Codes
on next page. (This command not active in Ver 2.0)
45718
IR Remote Type
0=IC-RC
1=HD2-RC
65478
Reset controller, similar to disconnecting power then restarting.
65487
Initialize to factory default settings: Power on, unlocked, display channel 11, channel
ring set to 4, 5, and 11, Group 0. Note that this command works even if TV power is
off or control is locked out.
65480
Enable constant Net transmit to the Head-End. This is used for measuring the signal
strength of the unit’s RF output. Press Enter to stop transmit or the unit will
automatically stop after 50 seconds.
65481
Display DA transmitter frequency control voltage – should be 2000 - 3150.
65482
Display iCC-Net RF receive signal strength. Shows
Net RX
if receiving the
iC-HE’s “heartbeat” pulse once per second,
!NET RX
if not.
65483
Display DF transmitter frequency deviation – should be 245 - 300
