2. Setup
PIO-16/16B(PCI)H, PI-32B(PCI)H, PO-32B(PCI)H
13
Step 2 Setting the Hardware
This section describes how to set the board and plug it on your PC.
The board has some switches and jumper to be preset.
Check the on-board switches and jumpers before plugging the board into an expansion slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.
Parts of the Board and Factory Defaults
Figure 2.1. to Figure 2.3. shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
Figure 2.1. Component Locations <PIO-16/16B(PCI)H> Board No.8756x
PIO/PI/PO-xx(PCI)H
SW1
BOARD ID
- Interface connector
(CN1)
37
20
19
1
36
18
21
2
SW1
BOARD ID
0
D
EF
8
SW1
- Board ID setting switch
(SW1)
- Built-in power setting
function
- Built-in power setting
function
Summary of Contents for PI-32B(PCI)H
Page 15: ...1 Before Using the Product 8 PIO 16 16B PCI H PI 32B PCI H PO 32B PCI H ...
Page 45: ...3 External Connection 38 PIO 16 16B PCI H PI 32B PCI H PO 32B PCI H ...
Page 49: ...4 Function 42 PIO 16 16B PCI H PI 32B PCI H PO 32B PCI H ...
Page 55: ...5 About Software 48 PIO 16 16B PCI H PI 32B PCI H PO 32B PCI H ...
