3. Hardware Setup
16
BX-956S User’s manual
Hardware Setup
-
Before you start, be sure that the power is turned off.
-
Remove only those screws that are explained. Do not move any other screw.
Attaching the CFast Attachment Fittings
(1) After inserting a CFast Card, fasten the bundled CFast attachment fittings with a screw.
*1 Attached screw (M3 x 6)
Figure 3.1. Attaching the CFast Attachment Fittings
-
Insert the CFast Card face up.
-
Screw holes may be damaged if screws are tightened with a torque greater than the specified
torque.The specified tightening torque is 3 – 3.5 kgf
⋅
cm.
-
If you use a CFast card other than the optional card, we cannot guarantee the specifications of this
product. To use the product within its specifications, be sure to use the optional CFast card.
-
To prevent potential damage caused by static electricity, take appropriate anti-static measures (for
example, wearing an anti-static wristband) when inserting or removing the CFast card.
-
Do not touch the electronic board components when inserting or removing the CFast card.
-
Do not touch the terminals on the CFast card. Doing so may damage the card.
-
Be careful not to mistake the orientation of the CFast card when inserting it. Also, do not use
excessive force when inserting the CFast card. Doing so may damage the connector.
-
Do not drop or otherwise subject the CFast card to strong impacts before insertion. Doing so may
damage the card.
CAUTION
