20
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to jam and are easier to control.
Use the power tool, accessories and cutting tools,
etc., in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work which needs to be done. Using a power
tool in ways for which it was not intended can lead
to potentially hazardous situations.
Service
Your power tool should be serviced by a qualified
specialist using only standard spare parts. This will
ensure that it meets the required safety standards.
as well as the additional safety instructions.
WARNING: Packaging materials
are not toys! Children must not
play with plastic bags! Danger
of suffocation!
symbols :
Warning / Danger!
Read manual before use
Always wear hearing
protection
Always wear safety
goggles
Always wear a dust mask.
Always wear protective
gloves
Attention! Laser radiation!
Do not look into the beam.
Laser class 2.
Laser beam
characteristics
In accordance with
essential applicable safety
standards of European
directives
Double insulated
SPECIAL SAFETY INSTRUCTIONS
FOR JIG SAWS
Important! Use of any
accessories or attachments
other than those supplied or
recommended in these
operating instructions can
mean the risk of injury.
Hold power tool by insulated gripping
surfaces, when performing an operation where
the cutting accessory may contact hidden wiring
or its own cord.
Cutting accessory contacting a
“live” wire may make exposed metal parts of the
power tool “live” and could give the operator an
electric shock.
Keep hands away from the sawing range. Do
not reach under the workpiece.
Contact with the
saw blade can lead to injuries.
Apply the machine to the workpiece only
when switched on.
Otherwise there is danger of
kickback when the cutting tool jams in the
workpiece.
Pay attention that the base plate rests
securely on the material while sawing.
A jammed
saw blade can break or lead to kickback.
When the cut is completed, switch off the
machine and then pull the saw blade out of the
cut only after it has come to a standstill.
In this
manner you can avoid kickback
and can place down the machine securely.
Use only undamaged saw blades that are in
perfect condition.
Bent or dull saw blades can
break, negatively influence the cut, or lead to
kickback.
Do not brake the saw blade to a stop by
applying side pressure after switching off.
The
saw blade can be damaged, break or cause
kickback.
Use suitable detectors to determine if utility
lines are hidden in the work area or call the local
utility company for assistance.
Contact with
electric lines can lead to fire
and electric shock. Damaging a gas line can lead to
explosion.
Penetrating a water line causes property damage or
may cause an electric shock.
Secure the workpiece.
A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always wait until the machine has come to a
complete stop before placing it down.
The tool
insert can jam and lead to loss of control over the
power tool.
Before any work on the machine itself, pull the
mains plug.
