Consort T871, Manual

Page: 8 / 32

5
T871 • T872 T871 • T872
6
Data-logging
1. Select the menu by pressing MODE .
2. Select [DATALOGGER] and press CAL .
Start the data-logging:
1. Select [STORE] and press CAL .
2. Select [ACTIVATE] and press CAL .
3. Select YES or NO and press CAL .
4. Select [INTERVAL] and press CAL .
5. Select the desired time interval between the data-logging (or MANUAL) and
press CAL .
6. Select [ALARM] and press CAL .
7. Select the desired time interval between the data-logging (or MANUAL), when
the alarm is activated, and press CAL .
8. Select [NUMBER] and press CAL .
9. Select the desired number of values to be data-logged and press CAL .
10. Press MODE to return to the measurements and to start the data-logging
according to the previous settings. When manual data-logging has been select-
ed, press STORE to put a next measurement into memory. In the meantime the
display shows the logging-number e.g. [#00027].
View the stored values on the display:
1. Select [RECALL] and press CAL .
2. Select [TABLE] or [PRINT] to display or print the stored data and press CAL to
continue. Follow the instructions on the screen.
3. In case [TABLE] have been selected press CAL to show the options.
4. Select [LOG#] and press CAL . Select the number of the first line to be shown
on the display and press CAL .
5. Select [SHOW] and press CAL . Select [Log#] (line numbers) or [Date] to be
shown on the display and press CAL .
Erase the stored values:
1. Select [ERASE] and press CAL . Follow the instructions on the screen.
RS232
1. Select the menu by pressing MODE .
2. Select [RS232] and press CAL .
3. Select [BAUDRATE] and press CAL .
4. Select the desired baudrate and press CAL .
5. Select [INTERVAL] and press CAL .
6. Select the desired interval between the transmitted data and press CAL . Pre-
set to zero if no automatic transmitting is required.
7. Select [ALARM] and press CAL .
8. Select the desired interval between the transmitted data, when the alarm is
activated, and press CAL . Pre-set to zero if no automatic transmitting is requi-
red.
9. Select [IDENTIF. No.] and press CAL .
10. Enter an identification number for the transmitted data and press CAL .