40000061 Iss 01
Important—please read
The silica sheath of the heating elements should not
be touched by hand, otherwise permanent marks
(devitrification) will occur during heating. WHEN
ASSEMBLING HOLD THE ELEMENTS BY THE CERAMIC
BUSHES AND OBSERVE THE CLEANING INSTRUCTIONS
AFTERWARDS.
Overview
Please read this guide carefully and retain for future
use and maintenance.
This appliance has been designed and
manufactured to the highest international
standards, however, care must be taken for optimal
results and safety. This appliance also meets the
requirements of EU Directive 2004/106/EC for EMC
and 2009/125/EC Directive.
Safety & Care
The appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Warning
Do NOT site the appliance into a corner.
Do NOT use the appliance in workshops or rooms
where excessive dust is generated or present.
Do NOT touch outlet grille when the appliance is
in use.
Do NOT cover or restrict any aperture of the
appliance when in use.
Do NOT use the appliance if damaged.
Do NOT leave the appliance unattended.
Cleaning
Always disconnect the heater from the mains before
cleaning. The heater should not require any
maintenance, but it is strongly advised that it is kept
clean. An occasional wipe over with a soft cloth is
all that should be necessary.
Do NOT use metal or furniture polish on any part
of the heater.
Do NOT touch the heater with wet hands or in
any way bring water into contact with it.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
2
If Your Heater Does Not Work
Check that power is available to the heater. The LED
light on the SL receiver should be illuminated
Check that the fuse in the spur unit has not blown. This
can be done by replacing the fuse with another
suitable fuse.
Check if the heater is paired with the SL controller
Should none of the above remedies work, then telephone
the helpline number shown in these instructions (UK ONLY).
Do not attempt to repair the heater.
Connection to the Main Supply
Electrical installation should be carried out by a
competent installer, preferably registered with NICEIC in
accordance with the 17 edition of the IEE Wiring
Regulations, (BS.7671), and any relevant Local Authority
Bye-Laws. This heater is fitted with a 3-core mains supply
cable and should be permanently connected to the
electricity supply via a double pole switch having 3mm
gap on each pole. A switched Fused Connection unit to
BS.1363. Part 4 is a recommended mains supply
connection accessory to ensure compliance with safety
requirements applicable to fixed-wiring installation.
Note: When switched on for the first time the appliance
may emit a slight smell.
WARNING: This appliance must be earthed.
When refitting the lid care must be taken to align the light
pipe on the lid with the indicator light.
Assembly
The Twin-Zone heater is designed to provide widespread
warmth (broad beam) or a more concentrated beam of
heat over a localised area (narrow beam), and the
selection of either is made by adjusting the position of the
element. This is determined by ensuring that the ceramic
blocks supporting the silica tubing are mounted into the
heater body in the correct position. Long end of ceramic
blocks downwards will give narrow beam and short end
downwards will give broad beam. (See Fig 2).
N
E
L
INDICATOR
LIGHT
