To raise the nipple, insert a screwdriver in hole
, Fig. 11 and loosen the set
screw therein. The eccentric adjusting stud
can then be turned by the wrench
provided so that nipple can be set at desired height, then tighten the set screw in
hole
.
otion to throw the machine out of action and make sure that it is
securely held in its looking position. Raise the needle holder to avoid breaking the
fter removing the thumb screw
14. THE LOOPER (Fig. 12)
Allow the stop m
point of the needle, remove the needle plate a
,
ig. 12, and observe the notch in the looper which, when in its correct position,
sh
,
F
ould be at the rear slightly to the right of the needle while the handle
toward the front.
is
13
Downloaded
from
www.aberdeensewing.com
