8
2
3
1
1
4
7. Installation
The doorbell transmitter comes equipped with batteries, therefore it is
ready for immediate mounting on the wall.
• Working from the side, lever the facing from the catch using a small
screwdriver. Place the device on a flat surface before carefully lifting the
facing off.
Make sure the pressure spring does not fall out.
• Using the two mounting holes provided (see illustration below) attach the
lower part with 3mm screws, for instance, to the wall.
• A nameplate may be inserted into the facing. To do this, carefully remove
the transparent cover in the facing with a small, flat screwdriver.
• Replace the upper casing (and snap back into place, paying attention to
the catch protrusions: two narrow protrusions on one side, one broader
one on the other).
1 Mounting holes
2 Small steel spring
3 Four screws for removing the lid in order to change the batteries
4 Lid