![background image](http://html1.mh-extra.com/html/conrad/fs20-s4ub/fs20-s4ub_operating-instructions-manual_2654598020.webp)
20
b) Setting the addresses
A channel’s address is comprised of a 2-digit address group and a 2-digit subaddress (for
example, 1131, address group 11, subaddress 31).
The address group ‘11’ is factory set for all channels.
If several transmitters are to be operated at the same time and control different receivers, then
different addresses need to be set on the transmitters.
1. Programming a single address in 4-channel operation
For programming purposes buttons ‘
TA1
’/’
TA2
’ and ‘
TA3
’/’
TA4
’ constitute a
button combination.
To change the single address (address group/subaddress) for a single button, proceed as
follows:
• Press and hold the button to be programmed.
• Then press the other button of the button combination and keep both buttons pressed
simultaneously for a minimum of five seconds.
• Then release both buttons.
• Use the ‘
TA1
’, ‘
TA2
’ , ‘
TA3
’ and ‘
TA4
’ buttons to enter a two-digit address group and a two-
digit subaddress.
Example:
1431 (address group 14, subaddress 31)
• The programming mode ends automatically once you have entered the fourth digit.
The following address combinations are preassigned to the buttons:
Buttons
1
2
3
4
Address
11 11
11 12
11 13
11 14
Please note:
The address group 44 and the subaddress 44 both have a particular meaning.
See section 6.