26- Installing the wing / Tragflacheneinbau
The hole on the bottom of the
wings and the slot on the side of
the fuselage are pre-drilled at
factory
Wing brace ( right - left)
To the bottom of the wing
To the side of the fuselage
L/R
3x15mm screw /
Schraube
............................2
Wing
3x15mm
sscrew
3x15mm
sscrew
The blindnut in the wing
is installed at factory.
Wing brace
90 ~ 95mm
30mm
15mm
Aileron
Rudder
27- Balance / Schwerpunkt
15mm
30mm
Querruderausschlag
Seitenruderausschlag
Do not try to fly an out-of balance model!
Uberprufen Sie vor dem Flug den Schwerpunkt.
15mm
15mm
Elevator
Hohenruderausschlag
Flap
20mm
All details are subject to change
without notice !
Technische Anderungen und Irrtumer
vorbehalten !
IMPORTANT:
Please do not clean your model with pure alcohol, only use liquid soap with water or use glass cleaner
to clean on surface of your model to keep the colour not fade.
This blindnut can be
move up and down
CA
CA
25- Decor / Aufkleber
Note: Cut out the stickers and apply them in the proper area.
Do not peel the backing paper off all at once. Peel off one corner of the backing and cut off
with scissors. Arrange sticker on model and when satisfied adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the
sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface
with the tip of the knife or sharp pin and squeeze out the air.
At curves stretch sticker and apply a little heat so that no ceases occur. Cut off the excess that is produced.
1
2
3
4
1
2
3
4
