- Place the new soldering iron in the support stand.
- Press the buttons „PRESET 1“ and „PRESET 3“ and keep these
depressed.
- Switch the soldering station on. The cali-
bration menu starts. The display shows the
following:
- Let go of both buttons.
☞
The calibration program starts with a heating up phase.
This takes approx. three minutes and is displayed with a
countdown from 15 to 1 in the TMP line. After this time,
the soldering tip temperature is approx. 270 to 400°C.
- The second stage starts automatically.
- The temperature of the soldering tip is con-
trolled. This is once again indicated by a
countdown from 24 to 0.
- The soldering tip temperature is stable after
approx. five minutes. The temperature is below 220°C here.
Avoid drafts of air under all circumstances during the
calibration phase. This could have a negative impact on
the calibration process.
- The third stage also starts automatically. Now you have to mea-
sure and set the temperature values.
- The display shows the following image. The
„TMP“ line shows three dashes, the „SET“
line shows the value of the temperature
control depending on its current position.
- Now measure the temperature on the soldering tip with a precise
measuring probe and read off the actual temperature on the ther-
mometer.
27
