CMx2-DisplayPort
CMx2-HDMI
Media Converter
Instruction Manual CMx2 Media Converter
page: 8
Possible Operation Errors CMx2 HDMI
Error
Possible reasons
Debugging
Notes
LED is off
The devices do not get any
power
Check the correct function of the mains
voltage
Red, steady flashing
on the receiver
1.) The module detects an
open fiber connection
2.) The fiber optic cable is
too long, or has increased
attenuation values
1.) Check if the fiber optic cable is plugged
2.) Check the proper function of the fiber
optic cable
Pink / purple, steady
flashing
The fiber connection is
open and the lasers have
been disabled.
Bootloader is connected.
Device is in bootloader mode
Yellow, steady
shining
The fiber connection
was detected, but the
connection initialization
failed
HDMI signal was not initialized. Make sure
that the connection is ok without the
CMx2 media converters.
Most common causes of error are sources
or displays which are not active
Starting up CMx2 HDMI
When all connections are fixed properly, the "Status" LED on
the side of the HDMI jacks on both devices lights in one of
the following colors:
Green, flashing - signal transmission without HDCP
Green, steady shining - signal transmission with HDCP 1.X
Blue, steady shining - signal transmission with HDCP 2.X
The image signal of the video source can now be seen on the
output medium.
If there is no fiber connection between the CMx2 transmitter
and the CMx2 receiver, the "Status" LED flashes red.
This is also for a fiber connection with excessive attenuation
or fiber optic cable length excess. So it is quite easy to locate
a fault within the fiber optic connection.
CMx2-HIN12-EB2M-RX
18270049_01
GEWICHT:
A3
BLATT 1 VON 1
MASSSTAB:5:1
ZEICHNUNGSNR.
BENENNUNG:
ÄNDERUNG
ZEICHNUNG NICHT SKALIEREN
WERKSTOFF:
DATUM
SIGNATUR
NAME
ENTGRATEN
UND SCHARFE
KANTEN
BRECHEN
OBERFLÄCHENGÜTE:
WENN NICHT ANDERS DEFINIERT:
BEMASSUNGEN SIND IN MILLIMETER
OBERFLÄCHENBESCHAFFENHEIT:
TOLERANZEN:
LINEAR:
WINKEL:
QUALITÄT
PRODUKTION
GENEHMIGT
GEPRÜFT
GEZEICHNET
