EasyScopeIII for DS60M10 User Guide
Version 1.3
Document Reference No.: CP_000037 Clearance No.: CP#027
Copyright © Connective Peripherals Pte Ltd
15
3.3.3
Volts/div Settings
The input gain is adjusted by clicking on the Volts/Div rotary switch on each of the channel settings
control panels as shown below. Channels A and B have independent gain settings.
The knobs can be rotated by the left mouse button (click and drag) or the arrow buttons on the
keyboard.
Figure 16- Volts/div Settings
There are 8 gain settings available. Please note that if a gain setting is too high for the input signal,
clipping will occur. To avoid clipping, select a larger voltage scale.
In addition, the settings depend on if the oscilloscope probe used is an x1 (1MΩ input impedance) or a
x10 (10MΩ input impedance). If an x10 oscilloscope probe is used then enable the X10 setting by clicking
on the X10 button located below the rotary switch. This will re-scale the switch.
The current gain setting is also displayed at the bottom right of the oscilloscope grid for both the
channels as shown in the figure below.
3.3.4
GND
The ground (0V) reference is shown by a small arrow on the left hand side of the screen. The colour of
the arrow matches the colour of the trace display. The default colours are yellow for channel A and red
for channel B as shown below.
