Astro Carrier for NVIDIA® Jetson™ TX2/TX2i
Users Guide
Document: CTIM-00456
Revision: 0.24
Page 33 of 47
Date: 2021-10-04
Note: The 8.65mm M/F stand-off comes with thread locker already applied. This will increase the
resistance when fastening this stand-off to the assembly. Therefore it is recommended to use a 3/16
socket driver during assembly.
3.
Connect your cables. At a minimum this would include:
a.
Power cable to the input power connector
b.
Connect a video display cable or use the serial console
c.
Keyboard and mouse via USB
4.
To connect power, the XBG201 or XBG206 Breakout Board comes with a power screw terminal
installed on the power connector. Connect your power wires into this terminal and install it onto
the Breakout Board to provide power to the system. DO NOT power up your system by plugging
in live power.
5.
Apply power. The system should automatically boot up without any need to push the power
button.
POWER SUPPLY
Connect Tech offers 12V 2A power supplies preconfigured for the XBG201 or XBG206 breakout board. It
is supplied by a standard AC line cord and has a cable length of approximately 1.5m. Contact our sales
department about the
MSG062 or MSG070
for more details. View the MSG062 drawing.
ON-BOARD INDICATOR LEDS
The Astro Carrier has 2 on-board indicator LEDs.
LED
Description
D10
Carrier Stand-by Power Good:
indicates the standby power is good.
D11
Carrier Power Good:
indicates all onboard power supplies are properly
regulated. It is only off in the event one of the onboard power supplies is
malfunctioning while the carrier power is enabled.