27
26
GB
GB
Replace the lamp
Caution!
Before replacing the lamp, shall disconnect the
appliance from mains power supply.
Lamp specification is listed in rating label.
Follow below process to replace the lamp:
1. Press and hold “Temp” button for 5
seconds to switch off the appliance.
2. Unplug the appliance to make sure
the appliance is disconnected from
main power supply.
3. Remove the screw of the lamp cover.
4. Pull the lamp cover out.
5. Unscrew the lamp.
6. Fit new lamp according to the
opposite direction, then replace the
lamp cover and screw.
7. Plug in the appliance.
Defrosting of the freezer
The freezer compartment, however, will become progressively
covered with frost. This should be removed. Never use sharp
metal tools to scrape off frost from the evaporator as you could
damage it.
However, when the ice becomes very thick on the inner liner,
complete defrosting should be carried out as follows:
• Pull out the plug from the socket;
• Remove all stored food, wrap it in several layers of newspaper
and put it in a cool place;
• Keep the door open, and placing a basin underneath of the
appliance to collect the defrost water;
• When defrosting is completed, dry the interior thoroughly
• Replace the plug in the power socket to run the appliance
again.
Trouble shooting
Caution!
Before troubleshooting, disconnect the power
supply. Only a qualified electrician of competent person must do
the troubleshooting that is not in this manual.
Important!
There are some sounds during normal use
(compressor, refrigerant circulation).
Problem
Probable cause
Solution
Appliance does not
work
Appliance is turned
off.
Press “Temp” but-
ton for 5 seconds to
turn on the appli-
ance.
Mains plug is not
plugged in or is
loose
Insert mains plug.
Fuse has blown or is
defective
Check fuse, replace
if necessary.
Socket is defective Mains malfunctions
are to be corrected
by an electrician.
