UNIWORLD Series
M/UNIWORLD-M/E ed. 01 2020
Figure 9
– Cam adaptation
The cams for intervention of the switches are positioned on the
limit switch plate and can be calibrated using a small screwdriver.
Cam 1 is for the screw drive that retracts, while cam 2 is to extend
the screw drive which extends outside the actuator.
ATTENTION
The potentiometer must not be set, non-compliance with this can damage the actuator
3.9
– STATUS DISPLAY / COMMISSIONING ELEMENTS
Figure 10
– Status display
A red and green LED inside the terminal box indicates the status
of the actuator.
Another single red LED (optional) indicates the status of the
fieldbus interface optional - see additional fieldbus manual.
The button that activates automatic commissioning (to start the
valve) is positioned inside the terminal box, under the
communication port.
3.10
– COVER CLOSURE
PSL 202
– PSL 210 AMS and BASIC VERSION (IP65) – See the label on the cover of the actuator.
ATTENTION
Ensure the cover is not assembled correctly and does not interfere with movement of the handwheel
stem. Insert the cover in the two reference internal notches
PSL 214 and PSL 202-110 AMS and BASIC VERSION (IP67)
-
Place the cover on the actuator and ensure the two locking screws are positioned over the relevant threaded holes.
-
Delicately tighten downwards and fasten the screws using an Allen key, if the screws won’t lock, move the cover gently.
-
Push the cover downwards and ensure it fits on the seal ring of the actuator.
-
Fasten the screws.
PSL 320
– 325 AMS and BASIC VERSION
Figure 11 Cover closure
-
Ensure the seal ring is positioned correctly in its
compartment.
-
Position the cover on the actuator and ensure the three
locking screws are positioned in the specific holes and
the button is positioned over the relevant pin inside the
actuator.
-
Screw in using a specific screwdriver
(2)
