Confer Plastics ROLLGUARD 7200 Assembly And Installation Manual Download

Page: 5 / 8

STEP 3:

HANDRAILS/DECK

Tools needed:

rubber mallet, cordless drill w/Phillips driver

Parts needed:

1- Deck
4- Handrails
1- Left bridge with lock assembly
1- Right bridge
2- #10 x 1-1/4” self tapping screws

#1-3: Push handrails up through bottom of deck leaving about 3” exposed.

#4: Align the inside/outside
rails with deck/handrail.

#5-6: Partially slide deck down locking handrails onto
ladder sections.

#7-8: Install right and left ladder bridges.

#10: Overlap the flat
sections at top of the
handrails and connect
using 1-#10 x 1-1/4”
self tapping screw.
Repeat for other
handrail.

#9: Finish tapping deck all
the way down until engaged
on to bridge.

65799-Confer-Model7200USr4.ps 3/23/09 2:46 PM Page 5

Summary of Contents for ROLLGUARD 7200

Page 1: ...NG ROLL GUARD A FRAME LADDER FOR RIGID FRAMED POOLS ONLY ASSEMBLY AND INSTALLATION MANUAL Proudly Made in U S A by SAVE THESE INSTRUCTIONS DEALER INSTALLER GIVE TO HOMEOWNER 65799 Confer Model7200USr4 ps 3 23 09 2 46 PM Page 1 ...

Page 3: ... surface 6 Lay IR rail on flat surface 7 Lift rotate and align tread tabs to fit into rail openings 9 Do Not Install bottom tread until Step 4 8 Tap all 4 treads down until seated 2 Correct tap down until seated note track is not blocked Incorrect do not block track 3 5 Install 3 more treads for a total of 4 see above pictures 65799 Confer Model7200USr4 ps 3 23 09 2 46 PM Page 3 ...

Page 6: ...to track grab handle first 2 6 Slide roll guard around to other side of ladder 4 5 6 7 8 Install bottom tread IMPORTANT this bottom tread MUST be installed to block the track roll guard must not come in contact with pool liner 9 Using a sharp knife carefully cut off the plastic tabs 10 Roll guard finished 65799 Confer Model7200USr4 ps 3 23 09 2 46 PM Page 6 ...