6
L10 SERIES RADIO CONTROL MANUAL
PN 701L10005.1.5
3.0 Standard Components (Continued)
3.2 Accessories
3.2.1 Accessories Per Radio Kit
1.
701L10005
- IOM (Installation and Operations Manual - L10
Series) (1 pc.)
2. Spare Fuse Kit
3. Radio Setting Sheets
3.2.2 Accessories Per Radio Transmitter
1.
700DIROP10
- Alkaline batteries for transmitter (2 pcs.)
2.
701C0026
- Strap for transmitter (1 pc.)
3.
701C0025
- Button legend sheet for transmitter (1 pc.)
4.
701C0041
- Protective Cover (1 pc.)
5.
701C0024
- Spare Key (1 pc.)
4.0 Installation Procedures
4.1 General Precautions
4.1.1 Observe all safety precautions when climbing or
working on the machine.
4.1.2 Turn off the main power source of cranes before
installation to avoid electric shock. Lockout/Tagout the main
power source.
4.1.3 Receiver must be installed as to not touch any part of the
machine or structure during the operation, except for mounting
provisions.
4.1.4 The receiver must be fastened securely via shock-proof mount
provided.
4.1.5 Before installation, inspect the crane’s safety devices and make
sure everything is in proper working condition.
4.1.6 Make sure you understand the crane circuits and
power distribution as well as the function setting of this
remote controller, to avoid incorrect wiring.
4.1.7 To avoid any interference, the receiver must be located
away from motors, frequency drives, and power cables (shown
on page 5).
4.1.8 Coil suppressors must be installed on all contactor coil and relay
coils. Conductix-Wampfler recommends RC type suppressors Conductix-
Wampfler Parts 103KVFCC1 with wire leads or 103KVFCC2 with bare
metal leads.
4.1.9 The receiver should be installed on the exterior surface of the
electrical control box. Mounting the receiver inside the electrical control
box is not correct. An external antenna kit (Conductix-Wampfler part
number 700DIROP9) must be used when receiver is installed in a metal
enclosure.
4.2 Receiver Preperation
4.2.1 Installation Preparation
1. Read through the following steps and procure all proper tools to
complete this installation.
2. Select a proper location.
a. Select a stable place free from electrical noise, vibration,
excessive heat, etc.
b. Select a place where you can see the receiver or antenna
from the ground.
c. Select a place where there is no interference (e.g. keep away
from motors, relays, magnetic switch, and power cables).
d. Keep away from high voltage wiring and devices.
e. The Receiver’s box must be at least 1.5” (4cm) away from
the other obstacles.
3. Receiver Power Supply. The input power source for the receiver can
be 110VAC, 220VAC, or 48 VAC 50/60Hz (for 12VDC please contact
Conductix-Wampfler). Measure your supply voltage, it must be within
10% of the selected above nominal voltages, failure to do so will void
the warranty.
NOTE: The Factory Default is 110VAC
L10 Receiver
Motor
Frequency
Convertor
Cable
Minimum of 3 feet Separation