10
L10 SERIES RADIO CONTROL MANUAL
PN 701L10005.1.5
5.0 Operation (Continued)
5.3 Programming
You can only complete radio remote setting if the transmitter has been
setup for remote setting at the factory.
5.3.1 ID-Code Remote Setting
ID-Code remote setting allows you to pair the new TX or RX if one of
them is damaged. Using ID-Code remote setting will make both the TX
and RX to have the same ID-Code.
5.3.1.1 Please make sure the following conditions before ID-Code
remote setting:
a) Both TX and RX are of the SAME model and frequency.
b) Place the transmitter as close as possible to the receiver to
avoid interference.
c) Turn off the RX power more than 10 seconds and turn it on
again.
5.3.1.2 ID-Code remote setting Instructions:
a) Press and hold the transmitter EMS button.
b) Press UP push-button and hold it.
c) Press DOWN push-button 4 times and release “EMS & UP”
push-buttons when the red light on the transmitter is flashing.
d) Start the system as usual.
5.3.2 Via Copier
The copier (Conductix-Wampfler Part Number 700PROC)
instructions are detailed in a separate manual. Please contact Conductix-Wampfler for information.
Attention:
*In case ID-Code remote setting fails, repeat the instructions above within 4 minutes.
*ID-Code remote setting is available for ID Code only. It will not change function settings.
*Within the operating distance, all same model systems on the same frequency will be paired with the transmitters ID Code.
*A jumper added inside the receiver is necessary to enable the ID-Code remote setting function.
Jumper to add for
ID-Code remote setting
L10 RX
Press and hold the
UP push-but
ton
Press EMS Button
Continuing press the
DOWN push-button for
4 times