Condari QASAIR 4F, Installation & User'S Instructions

Page: 28 / 56

Qasair Rangehoods Installation Instructions
28
REMOTE SWITCHING SPECIFICATIONS
3 FAN with LED
1. Wiring to the appliance must comply with State and local regulations.
2. Switching is not provided with this unit. - The order was for the controls to be separate from the unit.
3. You may use any switching to connect the rangehood (e.g. Clipsal switches).
4. All fans must be controlled by at least one ON/OFF and one HI/LO switch.
(i.e. single or twin motor models).
5. Please refer to Wiring Diagram below for detailed wiring information.
AC1 AC2
LED
AC2 AC1
LED
BLUE BLUE
BROWN
BLUE
BROWN
BLUE
BROWN
DRAWING NUMBER
CIRCUIT DIAGRAM
DESIGNER
CHECKED
M. Malesevic
REVISION
CONDARI PTY LTD
DATE
8 Argent Place, Ringwood VIC 3134
Ph: (03) 9873 5877 / Fx: (03) 9873 5748
REM SW 3 FAN LED
REMOTE SWITCH 3 FAN LED
A
22/08/2013
BROWN
BLUE
BLUE
BLACK
BROWN
M. Brewin
BLACK
BLUE BLUE
BROWN
BROWN
WHITE
GREEN
WHITE
GREEN
JUNCTION
BOXES
-------------------- CABLES TO REMOTE SWITCHES --------------------
NOTES:-
1. IT IS NECESSARY TO PROVIDE
AN ON/OFF AND A HIGH/LOW
SWITCH FOR EACH FAN.
2. THE WIRING FOR THE FANS ARE 4 CORE -
LOW SPEED - BROWN
HIGH SPEED - WHITE
NEUTRAL - BLUE
EARTH - GREEN
3. THE WIRING FOR THE LIGHTS IS 2 CORE -
ACTIVE - BROWN
NEUTRAL - BLUE
BROWN
BLUE
BROWN
BLUE
JUNCTION
BOXES
BLUE
BROWN
WHITE
GREEN
BLACK
BLUE
BROWN
JUNCTION
BOXES
www.condari.com.au
WIRING DIAGRAM
For further information, please contact Condari Pty Ltd
phone : 03 9482 7088 fax : 03 9482 7011
NOTE: This diagram is for reference only. A qualified elecrician must connect remote
switching to rangehood.
Reflected in this drawing is the most common method of connecting the rangehood.
Be aware that Active voltage must NOT be applied to both the ‘White- High’ or
‘Brown-Low’ wires at the same time. This will cause the fan to fail.
ALL FANS MUST BE CONTROLLED BY
AT LEAST ONE ON/OFF AND ONE
HI/LO SWITCH.