Condari CONDARY CON 60L, Installation & User'S Instructions

Page: 7 / 44

Qasair Rangehoods Installation Instructions
7
DUCT DIRECTION CHANGE INSTRUCTIONS
Before installing your rangehood check whether it has the fan mounted for back or top ducting.
For top ducting, the unit will have the air outlet at the top, and for back ducting, the unit will have the air outlet at the
back.
To change from top to back or back to top, proceed as follows:
Duct direction for ETN, NDCH and CON models
The motor shown is fitted to the back plate (P) and this plate is attached to the rangehood by screws (S). To change
from top to back, remove the filters, unplug fan(s). Undo all the screw (S), carefully remove the plate and turn it around
so the motor points out the way required. Fit and reconnect the fan(s), and fit all the screws again and tighten.
Duct direction for LIS / FA / EAS / WES / GRA and KEN
To change the duct direction, proceed as follows:
1. Remove the screws from the fan access panel and remove access panel (for EAS and WES models only).
2. Disconnect fan(s).
3. Unscrew the 2 x 7mm screws (B) fixing the fan to the hood. Remove fan entirely. Repeat for each fan.
4. Rotate the fan assembly and re-install so that the air outlet meets with the rangehood outlet hole through which
you are going to vent (top or back).
5. Replace the 2 x 7mm screws holding each fan.
6. Reconnect the fan(s)
7. Refit the fan access panel (for EAS and WES models only).
Rear Duct Position
Top Duct Position