59
Maintenance
Nortec GS
2583701_C_EN_1812_Nortec-GS_OM
1. Drain the tank, and shut down the humidifier as described in
.
2. Remove the side panel – refer to
"Removal and Installation of Access Panels" on page 54
3. Disconnect the two water hoses from the secondary heat-exchanger.
4. Flush the inside of the secondary heat-exchanger with clean tap water.
5. Reconnect the water hoses.
6. Disconnect the condensate trap from the secondary heat-exchanger and flush out any scale build-up.
7. Reconnect the condensate trap, and prime the trap with water.
8. Re-start the humidifier – refer to
"Restarting After Shutdown" on page 48
9. Check for leaks.
6.5.4
Cleaning the Float Chamber
Clean the float chamber in the fill box as follows. Refer to
Figure 14:
1
2
3
4
5
6
Cleaning Float Chamber
1 Screw (
×
3)
2 Sleeve, float
3 Float (
×
2)
4 Float chamber
5 Support, float chamber
6 Fill box weldment
CAUTION!
Risk of damage to the humidifier components!
