Condair Esco, Installation Instructions Manual

Page: 15 / 52

15
6. Mount valve unit.
• Remove protective cap/plug from the valve unit and the collector pipe.
• Push valve unit onto the connector of the collector pipe until it comes to a stop (the resistance
of the O-ring inside the valve unit must be overcome). Then, fix valve unit to the collector pipe
as shown below using the screws, washers and nuts (wrench size 13 mm).
Note: To improve the gliding ability moisten the steam connector of the collector pipe and the
O-ring inside the valve unit with water (do not use oil or grease!).
Water
Water