O
= unit is switched off.
1
= very low air flow
2
= very strong air flow
5. Select the desired air temperature using the regulator (5).
1
= low temperature
2
= mean temperature
3
= high temperature.
6. During drying, style your hair using a comb. Keep a safe distance in order to avoid burning the hair and skin, or
sucking your hair into the inlet grille.
7. The COOL function (flow of cold air) - is used for quick cooling of your hair, and subsequently gives better hold to
the hairstyle. To activate this function, press button (3).
8. When putting down the unit during use, always switch it off.
9. The removable nozzle enables aiming a narrow air stream towards the comb or brush you are using on your hair.
10. Switch the unit off after use.
11. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect it from the
wall outlet, as the proximity of water and any contact of the unit with water are very dangerous, even if the unit is
switched off.
12. The hanging loop enables you to hang up the unit to store it.
EN
19
VV5710
CLEANING AND MAINTENANCE
Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as they may damage it.
Check the cleanliness of inlet and outlet grilles after each use. If necessary, press the button for releasing of the inlet
grille (8), remove inlet grille, clean it and replace.
Never clean the unit under running water, do not rinse it or
submerge in water.
TROUBLESHOOTING
Problem
Cause
Solution
The motor is not
running.
The plug is inserted into the socket
incorrectly or insufficiently.
Check the plug connection.
The socket is not live.
Check to make sure voltage is present, e.g.
by using another appliance.
The supply cable is damaged.
Refer the unit to an authorized service
centre for testing and repair.
The motor has stopped
operating.
The air flow is incorrect or too low and,
consequently, the motor overheating fuse
has been activated.
Disconnect the power supply cable
from the socket.
Check and clear the air
passage on the inlet and outlet grilles.
Let the unit cool.
