Concept2 VP6200, Manual

Page: 38 / 100

38
EN
VP6200
OPERATING INSTRUCTIONS
Vacuum cleaner assembly
Always disconnect the plug out of the electrical outlet before assembling or removing accessories!
1. Attach the extension tube (5) into the hand unit of the vacuum (4) until you hear a click sound. To remove the tube
from the hand unit, press the release button (7) and pull away. By pulling the plastic part of the pipe (5), the pipe can
be bent in the joint. When straightening the pipe, you will hear a crack, the pipe will be fixed in a straight position
in the elbow.
2. Attach the turbo nozzle (6) to the extension tube (5), you will hear a click sound. To remove the turbo brush from
the extension tube, press the lock button (7) and pull away.
You can insert the turbo nozzle to the hand unit as described (4).
BATTERY INSTALLATION
Insert the battery (2) into the body of the hand unit (4) and push it lightly. When you hear a click, the battery has been
successfully installed. To release the battery, press the battery release button (3) and pull to remove it.
The battery charging point is located on the bottom of the handle of the hand unit.
Note: To prolong the battery life, always charge the battery when the battery is nearly empty. Do not store or recharge
the appliance in environment with temperatures below 0 °C or higher than 40 °C. These temperatures may damage the
appliance. During the charging process, the temperature of the appliance may increase, this is normal.
While the battery is being charged, the power indicator (D) flashes and remains lit after charging. If both indicators (E, D)
are lit during operation of the vacuum cleaner, the battery is sufficiently charged. If only one indicator is on or flashing,
the battery needs to be charged.
If you do not use the vacuum cleaner for more than 3 months, allow it to charge for 12 hours. Then place the vacuum
cleaner in a dry and cool place.
USE
Before installing the battery, check if it is fully charged.
1. Press the power button (A) located on the handle of the rod part of the vacuum cleaner to switch on the appliance.
2. By pressing the button (B) repeatedly, you can change the power of the vacuum cleaner (3 power levels are
available).
3. After switching the vacuum cleaner on, the 2nd power level is automatically set.
www.robotworld.cz