EN
47
CHECKING THE CONTAINER CONTENT LEVEL
If the suction power is lower, or the dust content level indicator l
ight is on
even though the nozzle is lifted
above the floor, empty the container immediately.
NOTE
: If the dust level indicator
light
remains o
n
after replacing the container, check for the following:
- some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are
obstructed;
- the motor filter is dirty;
- the air outlet filter is dirty.
Check for each of the possible causes above and eliminate the problem before you start vacuuming. If the
cause of the problem cannot be identified, hand over the product to the nearest service centre. Never use the
vacuum cleaner if the bag level indicator
light
is
on
during operation. The motor could be damaged irreparably
MAINTENANCE
As a preventative measure, we recommend emptying the container and
cleaning the filters of the vacuum cleaner after each use.
EMPTYING THE CONTAINER
1.
Unplug the vacuum cleaner from the mains. Disconnect the hose from
the suction inlet.
2.
Push the latches on the container holder, and shift the container upwards
(Fig. 3).
3.
Press the latch on the bottom of the r
ear
side of the container, open
the latch and empty the contents of the container (see Fig. 4).
4.
Close the container and return it to the vacuum cleaner. Make sure the
container is positioned properly. You should hear a clicking sound from
the handle latches.
REPLACING FILTERS
• The filters should be cleaned or replaced when they are visibly dirty, or if
the appliance‘s suction power is reduced. Always check the filters after
using the appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly
installed filters.
• Before replacing the filters, disconnect the appliance from the electrical
socket.
• You can buy suitable types of filters from your dealer, or you can order
them from the manufacturer.
CLEANING THE INLET FILTERS
1.
Disconnect the flexible hose and remove the container.
2.
Open the filter holder on the f
ront
side of the container (Fig. 5)
and remove the filter
(Fig. 6)
.
3.
The foam rubber filter
(Fig. 7)
may be cleaned mechanically by shaking
them and cleaning with a soft brush. Heavily fouled filters can be washed
after this step and cleaned with a soft brush in lukewarm water.
VP 5
200
Fig.
3
.
Fig.
4
Fig.
6
Fig.
5
