80
EN
PDV7575bc
INSTALLATION OF THE APPLIANCE
ATTENTION!
There is a risk of electric shock! Before installation of the appliance, disconnect the power cord from the
electrical socket.
y
Defects caused by improper installation are not covered under warranty.
y
The responsibility for the installation of the appliance is on the buyer, not the manufacturer.
y
The manufacturer bears no responsibility for damages to persons, animals and objects due to improper
installation.
y
Placing the appliance into suitable furniture will ensure its correct operation.
y
The appliance is installed into standard kitchen furniture
designed for built-in appliances or in appropriately modified
furniture with dimensions according to Fig. 3.
y
The edges of the hob must be at a minimum distance of
60 mm from a side or rear wall.
y
There must be at least a 700mm gap between the highest
point of the hob (including burners) and the bottom side
of the horizontal surface located directly above the hob
(excluding the kitchen hood).
y
If the side edge of the upper horizontal plate is flush with the
side edge of the hob, the minimum distance between the side
edge of the hob and the bottom of the horizontal plate above
the hob must be 400 mm.
y
If the bottom of the horizontal plate above the side edge of the hob is lower than 400 mm, its side edge
must be at least 50 mm away from vertical plane of the side edge of the hob.
y
The kitchen furniture must be made of heat-resistant material resistant to temperatures of at least 120°C.
The materials and adhesives used must withstand the warming of the appliance according to CSN EN
60335-2-6. Materials and adhesives not complying with this standard may deform or peel off.
y
The appliance must not be installed in the immediate vicinity of a kitchen cabinet made of flammable
material that extends over the surface of the worktop.
y
If there is an appliance located under the hob, there must be at least a 25mm gap between these two
appliances (see Fig. 4).
25 mm (MIN.)
45 mm
Fig. 4
400 mm
560 mm
480
mm
400 mm
700 mm
Min.
55 mm
200 mm
750 mm
min.30 mm
Fig. 3
