Concept2 OPV3860bc, Manual

Page: 65 / 74

65
OPV3860bc
EN
Recirculation mode
If there is no possibility of discharging the extracted air out of the room, you can use the recirculation mode. In this
case, the extracted air is filtered through the metal fat filters and the carbon filter. An active carbon in this filter absorbs
the smell. Air, free from the smell, flows back into the room through openings situated in the upper chimney cover.
When the recirculation mode is used, it is necessary to purchase and install the appropriate carbon filters (see chapter
Cleaning and maintenance).
1. Deploy the slide-out front to the desired distance.
2. When the slide-out front is deployed, all the buttons and the screen will be lit for a moment. Simultaneously, a
beep sound will occur to signalise the control panel buttons are active.
3. Press and hold the button (1) to turn the appliance on.
4. Using buttons (2) and (4) select the required value of the extracted air exhaust output.
5. The display shows the output value (1-3).
6. Push button (1) to switch the appliance off.
Note:
•
When the recirculation mode is used (carbon filter installed), the extracted air output can drop.
Turning the lights on/off
1. Deploy the slide-out front to the desired distance.
2. When the slide-out front is deployed, all the buttons and the screen will be lit for a moment. Simultaneously, a beep
sound will occur to signalise the control panel buttons are active.
3. Press and hold the button (5) to turn the lights on.
4. Press the button (5) again to turn the lights off.
Note:
•
Lightning cannot be turned on if the slide-out front of the appliance is inserted.
Notes
1. If the slide-out front of the appliance is inserted, the control panel is inactive and either the ventilation or the
lightning cannot be turned on.
2. The appliance or the lightning can be turned on only when the slide-out front is deployed.
3. When the slide-out front gets inserted, all the active functions are turned off and the control panel buttons
are deactivated.
CLEANING AND MAINTENANCE
• Disconnect the power cord from the wall outlet or switch off the circuit breaker of the appliance before cleaning
and maintenance.
• To clean the appliance outside, use a damp cloth, a soft brush or a fine sponge, and then wipe it dry.
• Do not use coarse abrasive cleaning agents or sharp metal scrapers for cleaning of the appliance as this could result
in surface scoring.
• Do not use steam jets to clean the appliance!
• Never leave aggressive or acidic substances (lemon juice, vinegar) on enamelled or stainless parts of the appliance.