EN
26
OPK4290
CLEANING AND REPLACING THE FILTERS
a) Metal fat filters
Under normal use, the metal fat filters should be cleaned every 2 months. In case of more frequent frying or
deep frying, shorten the interval.
Do not use the unit without properly mounted metal fat filters!
1. Remove the metal filters (Fig. 1). If carbon filters are mounted, remove them.
2. Put the metal filters in warm water with a detergent. Clean them with a soft brush, rinse with clean water and
let dry.
3. Remount the completely dry filters following the reverse steps.
Fig. 1
b) Carbon filters (must be purchased)
These filters are used only in the re-circulation mode.
The filters contain active carbon that absorbs the ventilated odors. After a while the active carbon is saturated,
and loses its absorption ability. These filters can‘t be washed or otherwise cleaned.
Under normal use the carbon filters should be replaced every 2 months. In case of more frequent frying or deep
frying, shorten the interval.
1. Remove the metal filters (Fig. 1), and remove the carbon filters from them.
2. Mount new carbon filters on the metal ones (Fig. 2), and put the set back.
Fig. 2
