6
FRANÇAIS
ENGLISH
ESP
AÑOL
ENGLISH
ESP
AÑOL
FRANÇAIS
FRANÇAIS
ENGLISH
ESP
AÑOL
ENGLISH
ESP
AÑOL
FRANÇAIS
4-5/8” – 120mm high on right angle cuts) by unlocking the sliding head and cutting
while sliding the head from the front to the back.
Note
: at extreme positions, the hold-down clamp should be moved to the right side
of the table to prevent it interfering with the movement of the cutting head. Always
check before making the cut if there is any potential interference from the clamp or
any other part of the machine.
NOTE:
Even though the angles are marked on the machine, it is always a good
idea to check them by making a trial cut.
Inspect the cord regularly and have it replaced by an authorized repair facility if it
is damaged
Check the brushes occasionally (after about 50 hours of use) and replace if
worn. Unplug the tool. The brushes can be replaced by removing the motor
back cap. The brushes and their springs could jump out of the holders- be care-
ful not to lose them. Inspect the brushes. If the contact surface is not smooth,
or it is worn, or heavily used, replace both brushes. Insert the new brushes and
springs in their holders and re-fasten the cap.
The two piece plastic table insert should be replaced if damaged to reduce the
risk of chips lodging in the slot and catching in the blade.
Keep the vents clear of dust and debris. This will help prevent possible electrical
shorts and ensure proper cooling.
Keep the tool housing and handle clean and free of oil and grease using mild
soap and a damp (not wet) cloth.
Lubrication is done at the factory and with the exception of the slide bearing,
should not be necessary again under normal use.
An authorized repair centre should do any repairs, modifi cation, or maintenance
that involve disassembling the saw.
Any damage to the tool should be corrected at an authorized repair centre.
WARRANTY
All products distributed by Airco Superior are warranted against manufacturers’ faults
All products distributed by Airco Superior are warranted against manufacturers’ faults
and defects for a period of one year from the date of purchase by the end user. The
Company will REPAIR OR REPLACE, AT ITS OWN OPTION, merchandise deemed
by the company to be defective, provided that is has not been misused, abused,
altered, or repaired by anyone other than an authorized repair centre. Retain proof
of purchase. Return the defective product to the place of purchase.
This warranty does not extend to parts deemed consumables, such as brad and
staple gun driver blades, grinding discs, electric motor brushes, welding contact tips,
etc. All warranty claims must have prior authorization and must be shipped prepaid
to the Richmond, BC or Mississauga, ON warehouses, or to an authorized repair
depot, accompanied by a copy of the invoice specifying the date that the item was
sold to the end user. You should take any tool with a problem back to where you
purchased it, accompanied by your receipt.
Call toll-free: 1 888 267 7713
OPERATING PROCEDURES
MAINTENANCE
