EN
77
MNV6560
TROUBLESHOOTING
Dishwasher users may resolve most minor faults that may occur during the dishwasher operation themselves without
calling the service centre. This will save them money and help them put the dishwasher back in operation. The following
overview table should be consulted in fi nding out causes of fault occurrences.
Problem
Cause
Solution
The dishwasher can't be
operated.
Plug inserted into the mains outlet
incorrectly or insuffi
ciently.
Check the plug connection.
The mains outlet is not live.
Check for voltage, e.g. by connecting another appliance.
The dishwasher does
not run.
The dishwasher is not closed
properly.
Make sure the dishwasher is ON and the door is closed
tight.
The water tap is not open.
Check to make sure the water supply is open.
The supply hose sieve is clogged.
Turn off the dishwasher and disconnect the power cable
from wall outlet. Close the water supply. Clean the sieve
located on the supply hose connection.
The spray arm turns with
diffi
culty.
The arm is blocked by dishes or
food particles.
Check the position of the dishes, or clean the arm.
The dishwasher
detergent container
can't be closed.
The container is full.
Remove the excess amount of dishwasher detergent.
The mechanism is blocked by stuck
remnants of dishwasher detergent.
Clean the closing mechanism of the dishwasher
detergent container.
The light indicators
do not go out after
washing.
The main switch is still ON.
Turn the dishwasher off by pushing the main switch.
Remnants of dishwasher
detergent are stuck in
the container.
The container was wet during
fi lling.
Pour the dishwasher detergent only into a dry
container.
Water remains in
the dishwasher after
washing.
The discharge hose is clogged or
bent.
Check the clearness of the discharge hose.
The fi lters are clogged.
Check and replace the fi lters.
The discharge pump is blocked.
Have the unit repaired by a qualifi ed specialist.
Soapy water in the
washing zone.
Unsuitable dishwasher detergent,
spilled rinse aid.
Use only dishwasher detergent designed for
dishwashers; if there is soapy foam in the washing zone,
leave the dishwasher open. Add 4.5 liters of cold water
to the washing zone, close the dishwasher and pump
out the water. Repeat the steps if necessary. Always
wipe up spilled rinse aid.
Stains in the washing
zone.
Colored dishwasher detergent
was used.
Do not use colored dishwasher detergents.
The dishes aren’t dry.
The rinse aid container is empty.
Make sure the rinse aid container is fi lled.
