Concept2 MNV5860, Manual

Page: 146 / 163

147
EN
MNV5860
PUTTING THE APPLIANCE INTO OPERATION
Starting the washing program
1. Open the appliance door.
2. Check the amount of the regenerating salt and refill if needed.
3. One by one pull out the upper and lower rack, load the dishes and then slide the racks back. We recommend
loading the lower rack first and then the upper rack (see „Loading dishware“).
4. Make sure that the water tap is open.
5. Press button (1) to turn the appliance on.
6. Press button (2) repeatedly to select the desired program. The display (4) shows the preset time of the selected
program. The wash program runs in the following order: ECO – Glass – 90min – Rapid – Pre-wash – Auto –
Intensive – Normal – ECO.
7. By pressing button (3) you can choose whether the upper spray arm, the lower spray arm or both will be
operating for the selected program. This is possible on all washing programs.
8. If you require a delayed start, press the delayed start function button (7) or (8) repeatedly. The delayed start can
be set up to 24 hours.
9. After selecting the program and adjusting, close the door of the appliance. The washing program or the
countdown of the delayed start will start.
10. You will hear an eight-fold beep sound after the washing program is done. During the beeping sound there is
a flashing symbol 0:00 on the display. The indicator for the selected wash program will be on and the display
will show „end“ after the eight-fold beep sound.
11. Open the appliance door and press button (1) to turn the appliance off.
Caution! Be careful while opening the door of the appliance, a large amount of water vapour can be released or
hot water can spurt. There is a danger of scalding!
12. Hot dishes are very fragile. We recommend leaving the dishes to cool down for about 15 minutes before
unloading.
Unload the lower rack first and then the upper rack to prevent the excess water from the upper rack flowing down on
the dishes in the lower rack.
Changing the program during the running washing program
If you decide to change the currently running program, make sure there is enough detergent in the dispenser,
or whether it was used and it is needed to be refilled before starting a new washing program (see „Loading the
detergent“).
1. Open the door slightly to pause the running washing program. Wait until the spray arms are completely
stationary.
2. Press and hold button (2) for more than 3 seconds. The appliance will switch to standby mode in which you can
change the washing program setting.
3. Close the door after you are done resetting. The washing cycle will continue after a few seconds.
Note:
• If you open the appliance door during the running wash program, the program will be paused.
• A beep sound occurs every minute to warn the door is open during the running program.