Concept2 MNV4160, Manual

Page: 163 / 170

163
EN
MNV4160
Dishes are moist
Dishes were loaded
improperly
See „Loading dishware“.
Insufficient amount of rinse
aid
Use more rinse aid.
You unload the dishes too
soon.
Do not unload the dishes immediately after
the washing program is done. Open the door
slightly to allow the excess steam to escape. Start
unloading when the dishes are almost cold to the
touch. Always unload the lower rack first and then
the upper rack to prevent the excess water from
the upper rack flowing down onto the dishes in
the lower rack.
Wrong washing program
was selected
The short washing program is less effective than
the long programs and the temperature is also
lower. Select longer washing program.
Cutlery with wooden handle
Draining water from these is more difficult. This
type of cutlery is not suitable for washing in the
dishwasher.
ERROR MASSAGE
If a fault occurs, the dishwasher will display the following error codes:
Code Description of error Possible cause
E1 Longer dishwasher filling time
The water taps are not open or the water supply is limited or
water pressure is too low..
E3
Failure to reach the required
temperature.
Heating element malfunction.
E4 Overflowing Some parts of the dishwasher are leaking
Ed
Loss of communication between the
control unit and the display
Open circuit or broken communication line.
Note:
• In case of overflowing turn off the main water supply and then contact the service.
• Before restarting the appliance, remove the excess water from the interior of the appliance.