Concept2 MNV3660, Manual

Page: 164 / 172

164
EN
MNV3660
Dishes are moist
Dishes were loaded
improperly
See „Loading dishware“.
Insufficient amount of rinse
aid
Use more rinse aid.
You unload the dishes too
soon.
Do not unload the dishes immediately after
the washing program is done. Open the door
slightly to allow the excess steam to escape. Start
unloading when the dishes are almost cold to the
touch. Always unload the lower rack first and then
the upper rack to prevent the excess water from
the upper rack flowing down onto the dishes in
the lower rack.
Wrong washing program
was selected
The short washing program is less effective than
the long programs and the temperature is also
lower. Select longer washing program.
Cutlery with wooden handle
Draining water from these is more difficult. This
type of cutlery is not suitable for washing in the
dishwasher.
ERROR MASSAGE
In case of failure, the display shows the error code.
Code Description of error Possible cause
E1
Filling the dishwasher with water takes
too long.
Check the water supply (tap is not opened, the water supply is
limited, water pressure is too low).
E3
Dishwasher does not reach the set
temperature.
Heating element malfunction.
E4 Dishwasher is overflowing Too much inflowing water. Check the water supply pressure.
E8 Water inlet valve malfunction Contact a qualified expert or a service.
E9 Button pressed for more than 30 seconds There is a problem with the water supply, or a defective button.
Note:
• In case of overflowing turn off the main water supply and then contact the service.
• Before restarting the appliance, remove the excess water from the interior of the appliance.