77
MNV2560
EN
Demounting
When demounting the dishwasher, it is important to proceed in the correct sequence of operations:
1. First, disconnect the dishwasher from the mains (pull out the plug).
2. Close the water supply.
3. Loosen the water drain and inlet hoses.
4. Loosen the fixing screws.
5. Demount the plate base when used with the dishwasher.
6. Pull out the dishwasher and in doing so pull out carefully also the water drain and supply hoses, and the supply cord.
TROUBLESHOOTING
Dishwasher users may resolve most minor faults that may occur during the dishwasher operation themselves without
calling the service centre. This will save them money and help them put the dishwasher back in operation. The following
overview table should be consulted in finding out causes of fault occurrences.
Problem
Cause
Solution
The dishwasher can't be
operated.
Plug inserted into the mains outlet
incorrectly or insufficiently.
Check the plug connection.
The mains outlet is not live.
Check for voltage, e.g. by connecting another appliance.
The dishwasher does
not run.
The dishwasher is not closed
properly.
Make sure the dishwasher is ON and the door is closed
tight.
The water tap is not open.
Check to make sure the water supply is open.
The supply hose sieve is clogged.
Turn off the dishwasher and disconnect the power cable
from wall outlet. Close the water supply. Clean the sieve
located on the supply hose connection.
The lower or upper spray
arm turns with difficulty.
The arm is blocked by dishes or
food particles.
Check the position of the dishes, or clean the arm.
The dishwasher
detergent container
can't be closed.
The container is full.
Remove the excess amount of dishwasher detergent.
The mechanism is blocked by stuck
remnants of dishwasher detergent.
Clean the closing mechanism of the dishwasher
detergent container.
The light indicators
do not go out after
washing.
The main switch is still ON.
Turn the dishwasher off by pushing the main switch.
Remnants of dishwasher
detergent are stuck in
the container.
The container was wet during
filling.
Pour the dishwasher detergent only into a dry
container.
Water remains in
the dishwasher after
washing.
The discharge hose is clogged or
bent.
Check the clearness of the discharge hose.
The filters are clogged.
Check and replace the filters.
The discharge pump is blocked.
Have the unit repaired by a qualified specialist.
