Concept2 LR2047bc, Manual

Page: 57 / 64

57
EN
LR2047bc / LR2047be / LR2047wh
USER MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene reasons. Wash
all removable parts with warm soapy water.
After installing the refrigerator, leave the appliance standstill for at least half an hour before connecting to the mains.
It is necessary to allow th
e cooling gases to set down. Then you can connect the refrigerator to the mains and let it run
for 2-3 hours to stabilize a normal operating temperature. A slight odour may occur during this time. It will go away as
soon as the appliance starts to cool. Then put fresh food inside the appliance.
Note : If a power failure occurs during the first run, wait for at least 5 minutes before switching on again or connecting
to the mains.
Setting the Temperature of Refrigerator Zone
1. Open the door of the appliance.
2. Internal temperature of the refrigerator compartment is automatically controlled
by the thermostat (Fig.1).
3. Turning the controller from position OFF to position MAX sets cooler temperature inside.
• the numbers shown on the controller do not indicate a specific set temperature, but a temperature level
•
If the thermostat is set to OFF, it is turned off and the appliance does not cool
• For short-term food storage in the refrigerator, set the thermostat between MIN–MED.
•
For long-term food storage in the refrigerator, set the thermostat to position MED and above.
•
The refrigerator should be operated for at least 24 hours to reach the desired cooling temperature.
Note
: Frozen water droplets may appear on the back wall of the refrigerator, it is a common phenomenon not a defect
of the appliance.
Fig. 1
MIN
OFF
MED
M
AX