REVERSE DOOR
•
Make sure the appliance is disconnected from the main and its empty.
•
The removal of the door it is necessary to tilt the appliance on the rear side but not put on the rear side to the
ground. That may damage the refrigerant cooling circuit. The surface under the appliance should be hard and
slippery.
•
All parts which will be dissassembled will be again assembled at the door on the other side.
•
This operation is recommended to take place in two or more persons.”
1. Unscrew the top hinge. Then lift the upper door and place it on a padded surface to avoid scratching.
2. Unscrew middle hinge and then lift bottom door and place it on a padded surface to avoid scratching.
3. Remove bottom hinge pin from right to left.
4. Move middle bracket from left to right. Than re-fit bottom door.
5. Re-fit middle hinge to left side. Ensure bottom door is aligned horizontally and vertically, so that the seals are
closed on all sides before finally tightening the middle hinge.
6. Unscrew top hinge pin from the hinge. Then turn the hinge over and screw hinge pin.
7. Re-fit upper door and then upper hinge on left side. Ensure upper door is aligned horizontally and vertically, so
that the seals are closed on all sides before finally tightening the upper hinge. If necessary, a spanner to tighten
the hinge.
1
5
6
7
2
3
4
40
LKV 4360
EN
Summary of Contents for LKV 4360
Page 2: ......