Concept2 IDV2260, Manual

Page: 67 / 74

67
IDV2260
EN
cooking session.
For the removal of food remains and the layer of grease use a glass scraper.
For cleaning the lukewarm heating plate use a cleaning agent and a paper towel. If the plate is cleaned while hot,
stains could appear on it.
Then wipe the plate with a damp cloth and wipe it dry using a soft cloth.
Cleaners
Use cleaners suitable for glass-ceramic surfaces, e.g. CERA, CLEN, Cera-fix, Sidol for ceran + steel.
Water stains can also be removed by means of lemon or vinegar.
Improper cleaners
Never use Coarse sponges, abrasive agents or aggressive cleaners such as the spray for cleaning ovens and stain
remover.
Scraper for glass
Tough dirt should be removed preferably by means of a glass scraper. Release the scraper.
Clean the heating plate with the edge only. The holder of the scraper could scratch it.
WARNING!
The scraper is very sharp. Danger of injury! After cleaning, secure the scraper again.
If the edge is damaged, release it immediately.
Metallic-gloss colouring
Metallic-gloss colouring appears after the use of unsuitable cleaners or abrasion of a cooking utensil bottom.
Its removal is very difficult. Use Stahl-Fix or Sidol for ceran+steel. Removal of this colouring in our service centres is
charged for.
Control panel
Keep the panel clean and dry.
Food residue and food that has boiled over may affect the performance of the controls
UNIT INSTALLATION
•
Only the customer is responsible for installation in situ. Defects caused by incorrect installation are not covered by
the warranty.
•
The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
•
To ensure the correct function of the unit, place it in suitable furniture.
•
The unit should be installed in standardised kitchen furniture designed for built-in appliances or in properly
adapted furniture of dimensions according to Fig. 2 and 3.
•
The kitchen furniture must be made of sufficiently heat-resistant material. The materials and adhesives used must
be resistant to heating of the unit according to standard ČSN EN 60335-2-6. Materials and adhesives that do not
meet the stated standard may deform or loosen.
Follow the installation instructions:
1. Remove all the covering and marketing materials from the unit before the first use. Install the heating plate in a cut-
out in the worktop of a minimum thickness of 38 – 40 mm, with the surface covered with a heat-resistant material.
The worktop must be installed horizontally and at the wall it must be sealed against leaking liquids. Ovens, the
combustion products of which could flow up under the heating plate, cannot be installed under the heating plate
without taking special measures.
2. The required dimensions of the built-in hole in the worktop are on Fig. 2. Leave min. 50 mm space for the adjacent
cabinets on the sides. Leave at least 50 mm free space behind the heating plate.