8
Battery Charging
The battery pack in the unit must be fully charged for 10-14 hours before use.
1. Insert the small plug on the end of the AC adaptor into the POWER-IN
CONNECTION Jack at the back of the desktop charger and plug the AC
adaptor directly into a standard 120V wall outlet.
FIGURE 4
(BATTERY COMPARTMENT WITH
FIGURE 5
(BATTERY COMPARTMENT WITH
1. Release the BATTERY COVER LATCH located on the rear side of the unit.
See Figure 3.
3. Install one (1)
four (4) "AAA" alkaline
batteries (not included) following the polarities as shown in Figure 4 and Figure 5.
Ni-Cd rechargeable battery pack (included) or
4. Reinstall the BATTERY COVER and lock the BATTERY COVER LATCH into
position.
2. Remove the BATTERY COVER from the BATTERY COMPARTMENT.
10
11
10
The FRS unit has a built-in power saver for maximum battery life. But when
the FRS unit is not being used, conserve battery power by pressing the
Remove the batteries if the unit will not be used for a long period of time.
NOTES:
power button to OFF.
9
®
120V WALL OUTLET
REAR VIEW OF THE CHARGER
TOP VIEW OF THE CHARGER
FRONT VIEW OF THE CHARGER
AC ADAPTOR
2. Place the FRS unit in the charging base upright and facing outward. The
CHARGE LED indicator on the desktop charger will light. If CHARGE LED
indicator is not lit, check position of FRS unit to insure charging contacts
on the unit are lined up with charging contacts on the desktop charger.
3. The CHARGE LED indicator will remain lit while the unit is in the charger.
FRS unit will take approximately 10-14 hours to fully charge before use.
NOTE
: 1. If the FRS units or the Ni-Cd rechargeable battery packs are not
placed in the charger correctly, the CHARGE LED indicator will not
NOTE
: You can not charge alkaline batteries.
2. Use only the CONAIR AC adaptor and rechargeable battery packs
supplied with this product.
light and the unit will not charge.
BATTERY Cavity
FRS Cavity
Battery Installation
BATTERY COVER
LATCH
FIGURE 3
(REAR VIEW)
BELT CLIP
BATTERY
COVER
LCD PANEL DISPLAY
B
C
D
E
F
A
G
H
VX SC
FRS1
FRS 2
BATT 1
BATT 2
UP
INSERT THIS SIDE
FACING OUT
®
®
A.
B. - TX icon.
C. -
D.
E.
F. - Displayed when the unit is in
- RX icon. Displayed when receiving a signal.
Displayed when transmitting a signal.
Displays the current VOLUME LEVEL.
SC
- Displayed during the CHANNEL SCAN mode.
VX
- Displays during the VOX mode.
LOCK mode.
G. - Displays the current BATTERY LEVEL.
H. - CHANNEL NUMBER. Changes from 1 to 22 as selected
by user.
