Comunello QUAD 24V HP, Installation And User Manual

Page: 38 / 156

38 COMUNELLO ®Copyright 2021 - All rights reserved
The third menu is the one defined as EXTENDED 2 and to access the programmable functions follow the instructions given in Tab. 4 :
EXTENDED
MENU 2 • Press the SELECT button and scroll the LED menu until you
reach the LEV LED;
• Press SET twice to access the EXTENDED menu 2.
The LED of the LEV function FLASHES with this frequency
LIVEL 2 - EXTENDED MENU 2
LED FUNCTION DESCRIPTION LED ON LED OFF DEFAULT
L1 BRAKE Enabling of the electronic brake Enabled function Disabled function
L2 STEP BY STEP 1 Step-By-Step logic Open-Stop-Close-Stop (It DOESN'T close after the pause time in a
partial opening phase) Disabled function
L3 ALWAYS CLOSE Enables the sending of a CLOSE
command when the power is
turned on again Enabled function Disabled function
L4 FOLLOW ME The motor automatically closes in
5 sec after passing through DS1
photocell Enabled function Disabled function
L5 PEDESTRIAN TIME Storage of motor no.1 partial
stroke with slowdowns Partial stroke of motor no.1 stored 10 sec., without slowdowns
L6 2°CH
MONOSTABLE /
BISTABLE/TIMED
MONO. Setting the aux. relay of the
2°CH as Bistable / Monostable /
Temporised monostable Bistable command Monostable command (impulsive)
L7 REMOTELY
PROGRAMMING Enable the remote control
memory function without acting
on the control unit Enabled function Disabled function
Table 4
The fourth and last menu is defined as EXTENDED 3 and to access the programmable functions follow the instructions given in Table 5 :
EXTENDED
MENU 3 • Press the SELECT button and scroll the LED menu until you
reach the LEV LED;
• Press SET 3 times to access the EXTENDED menu 3.
The LED of the LEV function FLASHES with this frequency:
LIVEL 3 - EXTENDED MENU 3
LED FUNCTION DESCRIPTION LED ON LED OFF DEFAULT
L1 SOFT STOP Setting of gradual slowdown at
the end of the movement Enabled function Disabled function
L2 SOFT START Setting of gradual slowdown at
the beginning of the movement Enabled function Disabled function
L3 RELEASE STROKE
MAX FORCE/
RELEASE STROKE Before opening, the closing thrust
is activated for the electric lock
release Active function Disabled function
L4 SLAM LOCK MAX
FORCE / SLAM
LOCK Activation of the push in closing
for electric lock release Active function Disabled function
L5 ELS / CMD PED Activation of the electric lock as
PPED input Enabled function Disabled function
L6 LAMP/INDICATOR
LIGHT/COURTESY
LIGHT/ Flashing light set as pilot light or
courtesy light The courtesy light / warning light becomes an intermittent output, while
the lamp output becomes a courtesy light” Flashing light
L7 PRELAMP / LAMP
IN PAUSE Activation of the pre-flashing of
3 sec. before closing / Flashing
during the pause time Active function: preflash in closing / Flash during pause
time Disabled function
Table 5
Note: The control unit allows to be programmed if all the safety devices (N.C. inputs on terminals) grant a contact closed.