Comtrol RocketModem III, Hardware Installation

Page: 11 / 13

Hardware Installation 11
General Information
General Information The following table illustrates RocketModem III specifications.
Description Specification
M
o
dem
Characteristics
Supported standards
V.90, K56Plus, V.34,
V.32 terbo , V.32 bis , V.32,
V.22 bis, V.23, V.21, Bell
212A, Bell 103
Error correction V.42, MNP2-4, MNP-10
Data compression V.90, V.42 bis , MNP-5
Fax group Group 3
Fax class Class 1.0 and Class 2
Reset Software controlled
Baud rate 300 to 56 Kbps, 14.4kbps fax
Power consumption regular per modem 390 to 500 MW
Power consumption Sleep Mode per modem 100 to 110 MW
Transmit/Receive level 10 (Tx), 43 (Rx) Dbm
RocketModem III Specifics
Bus interface (meets Universal PCI 2.1
specification or higher)
Universal PCI
Board dimensions (including bracket) 13.3” by 4.2” (w x h)
Boards per system 4
Current consumption:
+3.3V
+5V 1.29 A maximum
5.04 mA maximum
Device driver control:
Data bits
Parity
Stop bits 7 or 8
Odd, Even, None
1 or 2
Dielectric withstanding voltage 1650 VRMS
DTE speed Up to 115,200 bps
Heat output:
4-Port
8-Port 8.9 BTU/hr
14.54 BTU/hr
Low Power Sleep Mode Yes
Mean time between failures:
4-Port
8-Port 22.7 years
13.3 years
Modems per board 4 or 8
Modems per system 4 to 32
Power consumption (board):
4-Port
8-Port 2.6 W
4.26 W
Telco connector RJ11
Tip/Ring current (continuous) 0 - 120 mA
Voltage requirement 3.3V or 5V system 3.15 - 3.45 VDC
Weight (board only):
4-Port
8-Port 8 oz
11 oz