Comtrend Corporation WAP-5883, Quick Installation Manual, Page: 11 / 16

E. AP Mode Installation Guide
In order to build a wireless networking environment, switch the WAP-5883 to
(AP) mode and connect it to your wired router or switch.
Setup via WPS button:
(1) Insert the WAP-5883 into a power outlet on the wall and switch to ‘ AP ’
mode.
(2) Use an Ethernet cable to connect the extender to the Ethernet port of your
router or networking switch.
Note: In AP mode, when you try to make a connection with a wireless client
using WPS, push the WPS button twice on this device within 5 seconds and
the ‘ WPS ’ LED will start flashing.
Switch to ‘
AP
’ mode.
Plug the WAP-5883 into a
power outlet on the wall, and
flip the power switch to ‘ ON ’ (1).
You should see the ‘ Power ’
LED light up in a few seconds
(2). If not, check if the power
outlet you’re using is working.
Use your computer’s wireless
configuration utility to search
for the access point named
‘ comtrend ’ to get connected.
(1)
( )
Signal
WLAN
Power
WPS
WPS
LAN
2
AP
Repeater
Client
10