16
Step 7
To change a WAN IP address, enter the ATM interface menu, e.g.,
MAIN/QC/ATM/ATM1
(refer to Section 4.2.2, ATM Interface, for
details).
Step 8
Hold down the Ctrl-S keys to save the IP address.
Step 9
Enter the
MAIN/CONF/SYSTEM
menu to set the passwords.
Step 10
You can enable the console password check function in the Console
Password Check field. After you enable it, a password will be
required to access the device through the console.
Step 11
Enter the ADMINISTRATOR password in the New Administrator
Password field, and retype the password to confirm.
Step 12
Enter the USER password in the New User Password field, and
retype the password to confirm.
Step 13
Hold down the Ctrl-S keys to save the parameters.
Step
14 Return to the main menu and select
WRITE
to write the
configurations to the flash memory.
Step 15
Return to the main menu and select
REBOOT
to reboot the system.
Step 16
In less than one minute, the sentence
“Press ESC key to enter
console mode configuration”
displays
.
Note 1: If you use HyperTerminal for the VT-100 emulation program, Edition 5.0 is
recommended.
Note 2: After changing the parameters, make sure that you save them in the flash
memory and then reboot the system before you quit. Otherwise, you will lose
the new parameters.
3.2.2 Telnet
Telnet can be used by maximum one ADMINISTRATOR and two common users
at the same time.
Step 1
Telnet to the device with the LAN IP address or WAN IP address
(refer to Section 3.1.1, Steps 5-8 for information on setting the
LAN/WAN IP address). The default LAN IP address is
210.65.231.206.
Step 2
You will be prompted to enter your user name and password.
Comtrend Corporation
CT-510 ADSL Router
Login:root
Password:****
To have full access privileges as an ADMINISTRATOR,
type
root
in
the Login field. If the default password was changed, type the
password that was set in the console session (refer to Section
