35
PAIRING
This process is to match the PU with BU so that they can communicate with
each other while no other devices (even baby monitor of identical model) can
interfere withyou or receiving your signal.
The PU and BU are already paired when they are shipped from factory.
However, in case you still encounter interference, perform pairing again to
achieve better privacy
1. Press and hold the down button 2 of PU.
2. Switch on the unit by long press of button 1. The power indicator 3 should
start flashing green. Release both buttons.
3. Press and hold the down button 8 of BU.
4. Switch on the unit by long press of button 7. The power indicator 9 should
start flashing green. Release both buttons.
5. Now press again down button 8 of BU, if pairing is successful, two beep
sound will be heard in PU. The power indicator 3 and 9 of both BU and PU
should show steady green.
6. The baby monitor is now ready for operation and probably a feedback noise
will be heard in speaker 5 of PU.
7. In case the PU and BU cannot communicate with each other, repeat pairing
process again.
OPERATION
Baby unit (BU)
1. Place the BU about 1 m from the crib with the microphone 12 facing towards
the baby. Switch on the unit by long press of button 7, the power indicator
9 will show steady green. If this indicator starts flashing green, the battery
level becomes low. Either replace with new battery or change using the
supplied AC adapter as power supply.
2. Adjust the microphone sensitivity using the button 8 such that the unit will be
set to transmit whenever the microphone 12 picks up a sound at your
desirable loudness level. The transmit indicator 10 will blink every time these
buttons are pressed, more number of blinks means the microphone is more
sensitive to sound (maximum is 5 blinks and minimum is 1 blink). Press to
increase and to reduce microphone sensitivity.
CT-2400_Manual_04.pdf 35 28/4/14 6:03 pm
