Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 192 / 516

SLM-5650A Satellite Modem
Revision 10
Base Modem HTTP Interface Operation 9–20 MN-SLM-5650A
Table 9-1. Router Stats Page – Drop-down “Feature Select” Items
Feature Select Item Attribute Description
FPGA
FPGA Link Errors
The count of received frames that did not match the
proprietary HDLC address, bad HDLC CRC, bad
alignment, and under run.
FPGA Overrun Errors
Count of received frames that exceeded max frame
length of 2K bytes in length.
FPGA Rx Packet count Total number of received frames.
FPGA Overflow Errors
Count of received frames that overflowed the HDLC
buffer.
FPGA TX Packet counts Total Number of transmitted frames.
(Ethernet features)
LAN Port 1
(NP Interface Traffic Port
marked as 1)
LAN Port 2
(NP Interface Traffic Port
marked as 2)
LAN Port 3
(NP Interface Traffic Port
marked as 3)
LAN Port 4
(NP Interface Traffic Port
marked as 4)
WAN
(Traffic port connected to
satellite interface)
Management
(Management port for
accessing M&C)
Good Octets (in)
Total good Ethernet frames received, that is frames that
are not bad frames.
Bad Octets (in) Total bad Ethernet frames received.
Unicast (in)
The number of good frames received that have a
Unicast destination GMAC address
Broadcast (in)
The number of good frames received that have a
broadcast destination GMAC address.
Multicast (in)
The number of good frames that have multicast
destination GMAC address.
Note: this address not included 802.3 Flow Control
messages counted in Pause (In) or does it included
Broadcast frames counted in Broadcast (in).
Pause (in) The number of good Flow Control frames received.
Undersize (In)
Total frames received with length of less than 64 octets
but with valid FCS.
Fragments (in)
Total frames received with length of less than 64 octets
but with invalid FCS.
Oversized (in)
Total frames received with length of more than Maxsize
(1518 for all modes) but with valid FCS.
Jabber (in)
Total frames received with length of more than Maxsize
(1518 for all modes) but with invalid FCS.
Rx Err (in) Total frames received with RxErr signal from PHY.
FCS (in)
Total Frames received with a CRC error not counted in
Fragments (In), Jabber (In) or RxErr (In).
Octets (Out) Total Ethernet frames sent from this GMAC
Unicast (Out)
The number of frames sent that have a Unicast
destination GMAC address.
Broadcast (out)
The number of frames sent that have a Broadcast
destination GMAC address.
Multicast (Out)
The number of frames sent that have a Multicast
destination GMAC address.