Comtech EF Data CDM-550T, Manual

Page: 173 / 178

CDM-550T Satellite Modem Revision 0
KST-2000A FSK Remote Operation MN/CDM550T.AA1
MN/CDM550T.AA1 5
1.2.7 (ODU,ENABLE, CONFIG,TRANSMITTER) ATTEN (Attenuation)
EDIT ODU TX ATTENUATION:
15.00 dB (PRESS ENTER)
The user is prompted to edit the transmit attenuation. This is accomplished by
selecting the digit to be edited, using the [
←
] [
→
] keys. The value of the digit is
then changed using the [
↑
] [
↓
] keys. The user then presses <ENTER>.
1.2.8 (ODU,ENABLE,CONFIG,TRANSMITTER) OUTPUT
SELECT KST TX OUTPUT:
OFF ON WARM (ENTER)
The user is prompted to select either ON, OFF, or WARM using the [
←
] [
→
]
keys, then press <ENTER>.
•
WARM is OFF, if COLD.
•
WARM is ON, if warm and NO FAULTS
•
FAULTS present, stays WARM and OFF indefinitely
1.2.9 (ODU,ENABLE,CONFIG,TRANSMITTER) HPA
CONFIG HPA: STATE
FAULT-LOGIC (ENTER)
1.2.10 (ODU, ENABLE,CONFIG,TRANSMITTER) STATE
SELECT KST HPA STATE:
ON OFF (PRESS ENTER)
1.2.11 (ODU,ENABLE,CONFIG, TRANSMITTER) FAULT-LOGIC
SELECT HPA FAULT LOGIC:
SUMMARY NO-SUMM (ENTER)
The user may select from the options shown, using the
[
←
] [
→
]
keys, then press
<ENTER>
.
Note: If the HPA power is OFF, it cannot report errors, answer messages,
provide serial numbers, etc.