15
16
The transceiver automatically switches to Transmission Mode when the VOX circuitry
senses that you have begun speaking into the microphone.
1. When operating the VOX function, be sure to set the VOX Gain level which allows the
transceiver to recognize the sound levels.
2. If the microphone is too sensitive, the transceiver will begin transmitting when there is
noise in the background.
3. If it is not sensitive enough, it will not pick up your voice when you begin speaking. Be
sure to adjust the VOX Gain level to an appropriate sensitivity to allow smooth transmission
10.6. -SCAN/FAST SWITCHING CHANNEL
*
Channel scan
Press [MONI] key to start scanning from the current channel and the radio will scan the
channel numbers one by one on the list which we programmed before. Once a valid signal
is detected, it will switch to this channel directly. You can press [PTT] key to transmit. Press
Scan key again to exit radio scanning.
Note: The Scan status will not be memorized once the radio is powered off.
*
Resume scanning Mode
To configure the scanning mode as following:
Carrier: Scanning stops on an active channel until there is no activity, it resumes scanning
after 5 seconds without activity on this channel.
Timer: Scanning stops on an active channel only for 5 seconds before it resumes scanning.
Seek: Scanning stops on an active channel and exit scanning mode at the same time.
*
Priority Channel Scan
Sometimes you may need to keep an eye on a prefer channel while you are scanning other
channels. You can set up any channels as the priority channel, which means the radio
will scan this priority channel and other normal channels alternately. Press the programmed
*
Priority Channel Scan key to activate this function and press this key again to exit. For
example, there are 3 channels CH1, CH2, CH3 and 1 priority channel on the scan list.
Then the priority scan will become:
CH1
*
Pri
*
CH2
*
Pri
*
CH3
*
Pri
*
CH1
*
Pri
**
10.7. -CHANNEL FREQUENCY-REPORT
If you want to know the frequencies of selected transmit and receive, also the QT we setter
on transmitting and receiving, press [MONI] key and until has noise, then press the [F]
key. Broadcast order: "transmit Storage ", transmit frequency, and transmit QT. "Receiving
Storage", receiving frequency, receiving QT. After reported frequency, If it did not report
the DQT and QT that indicating that the channel is not set QT, or continue to broadcast
DQT and QT , when broadcast frequency and QT, I "beep" sound that appears to indicate
"point. "After reporting the DQT "beep" sound occurs, expressed as a positive DQT, a
"beep, beep" twice, indicating that the reverse digital tone.
10.8. -EMERGENCY ALARM
The radio can be loud, penetrating strong alarm sound; it can make somebody draw
attention to the roll call.
*
Alarm function: Press the [SOS] button to start alarm function, when the green lights, red
lights, hand lamps blink at the same time.
*
Cancel alarm: In the alarm status, press [F] or [PTT] button or turn off the power to cancel
the alarm.
Summary of Contents for R8
