NARCOTICS BOX
with CompX cabinet eLock
Part #: 333697-0000-00
Copyright 2017 © CompX Security Products / 847.752.2500 / compx.com / 715 Center St., Grayslake, IL 60030
Any companies and/or products referred to herein are marks or registered trademarks of their respective companies, owners and/or mark holders.
What’s in the box?
w
1 - NARCOTICS BOX w/installed 200 or 300 Series eLock
w
1 - 12V to 9V power converter
w
1 – grommet for use w/converter
w
1 – 2-piece magnetic door position switch
w
4 – #10 x ¾ Phillips pan head sheet metal screws to hang
NARC box
w
1 - warranty card
w
1 - serial code sticker set
w
1 - in-box instructions
What’s needed?
w
6 – AA batteries (optional if 12V to 9V converter is used)
w
Drill
w
9/64” drill bit (pilot hole for mounting screws)
w
1/2” drill bit (if 12V to 9V converter is used)
w
#3 Phillips bit or driver
w
Tape measure
w
T15 pin-in Torx (6-lobe) bit
or driver (battery cover)
Care and
Cleaning
To clean the surface of
the eLock, apply non-acid
based cleaner to a clean
cotton cloth; do not spray
cleaner directly on the
eLock.
Wipe down keypad
and housing taking care
around the beeper opening
and edges of keypad.
Wipe excess cleaner off of
all surfaces.
Installation
The NARC box can be installed using the 4 predrilled key
holes and supplied #10 x ¾ Phillips pan head screws. Be
sure to mount the box in a location that provides enough
clearance for the door to open.
NOTE:
The NARC box may be equipped with a 12V –
9V converter to wire 12V DC power. If the converter is used,
drill a ½” diameter hole in the most convenient area and
install the grommet (included) and feed the cable through
the grommet.
IMPORTANT:
w
Connect red wire to positive terminal and
black wire to negative terminal.
w
Neglecting to install the grommet may
lead to electrical short circuit / eLock
malfunction and void warranty.
